BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS REAR SPEED SENSOR INSTALLATION
CAUTION / NOTICE / HINT
- HINT:
- ·
Use the same procedure for the LH side and RH side.
·The following procedure is for the LH side.
·If the rear speed sensor rotor needs to be replaced, replace the rear axle hub and bearing assembly.
·The rear speed sensor is a component of the rear axle hub and bearing assembly. If the rear speed sensor is malfunctioning, replace the rear axle hub and bearing assembly.
PROCEDURE
42450B
1.INSTALL REAR AXLE HUB AND BEARING ASSEMBLY
Install the rear axle hub and bearing assembly.
Click hereDrivetrain>AXLE AND DIFFERENTIAL>REAR AXLE HUB>INSTALLATION
- HINT:
- ·
The rear speed sensor is a component of the rear axle hub and bearing assembly. If the rear speed sensor is malfunctioning, replace the rear axle hub and bearing assembly.
·If the rear speed sensor rotor needs to be replaced, replace the rear axle hub and bearing assembly.
2.INSPECT REAR AXLE HUB BEARING LOOSENESS
3.INSPECT REAR AXLE HUB RUNOUT
42431
4.INSTALL REAR DISC
5.INSTALL REAR DISC BRAKE CALIPER ASSEMBLY
46430
6.CONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY
7.ADJUST PARKING BRAKE
58804A
8.INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY
89516D
9.CONNECT SKID CONTROL SENSOR WIRE
Connect the connector to the rear speed sensor.
10.INSTALL REAR WHEEL
11.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
- NOTICE:
-
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
-
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
12.CHECK FOR SPEED SENSOR SIGNAL