PARKING BRAKE  PARKING BRAKE SYSTEM  ADJUSTMENT  


PROCEDURE

Hide 1.INSPECT PARKING BRAKE LEVER TRAVEL

a.

Firmly pull the parking brake lever.


b.

Release the parking brake lever lock and return it to its off position.


c.
C291461

Slowly pull the parking brake lever to the fully applied position, counting the number of clicks.

Parking Brake Lever Travel:

6 to 9 notches at 200 N (20 kgf, 45.0 lbf)


If the parking brake lever travel is not as specified, adjust the parking brake lever travel.


Hide 2.ADJUST PARKING BRAKE LEVER TRAVEL

a.

Remove the upper console panel sub-assembly.

Click hereVehicle Interior>INTERIOR PANELS / TRIM>FRONT CONSOLE BOX>REMOVAL


b.

Release the parking brake lever lock and return it to its off position.


c.
C291462C01
0.802,1.052 1.479,1.052 1.479,1.052 1.99,1.427 false 1.292,1.792 1.667,1.792 1.667,1.792 1.917,1.521 false 0.646,0.979 0.958,1.135 0.313,0.156 10 false *1 1.125,1.708 1.438,1.865 0.313,0.156 10 false *2
*1 Lock Nut
*2 No. 2 Wire Adjusting Nut


Loosen the lock nut and No. 2 wire adjusting nut to completely release the parking brake cable.


d.

Fully pull the parking brake lever 3 to 5 times with the engine stopped.


e.

Turn the No. 2 wire adjusting nut until the parking brake lever travel is corrected to be within the specified range.

Parking Brake Lever Travel:

6 to 9 notches at 200 N (20 kgf, 45.0 lbf)



f.

Using a wrench or an equivalent tool, hold the No. 2 wire adjusting nut and tighten the lock nut.

Torque:
6.0 N*m (61 kgf*cm, 53 in.*lbf)


g.

Operate the parking brake lever 3 to 4 times, and check the parking brake lever travel.


h.

Check that the parking brake does not drag.


i.

Install the upper console panel sub-assembly.

Click hereVehicle Interior>INTERIOR PANELS / TRIM>FRONT CONSOLE BOX>INSTALLATION


Hide 3.INSPECT REAR DISC BRAKE CYLINDER OPERATION LEVER AND STOPPER CLEARANCE

a.
C172135C01
0.656,1.521 1.688,1.521 true 0.677,1.958 1.854,1.958 true 0.479,1.865 0.792,2.021 0.313,0.156 10 false *a 0.479,1.438 0.792,1.594 0.313,0.156 10 false *b
*a Operation Lever
*b Stopper


Release the parking brake lever and check that the clearance between the rear disc brake cylinder operation lever and the stopper is as specified below.

Clearance:

0.5 mm (0.0197 in.) or less


If the clearance is not as specified, replace the rear disc brake cylinder assembly.


Hide 4.INSPECT BRAKE WARNING LIGHT

a.

When operating the parking brake lever, check that the brake warning light illuminates.

Standard:

The brake warning light always illuminates at the first click.