K313 CVT PATTERN SELECT SWITCH INSPECTION
PROCEDURE
84720A 1.INSPECT NO. 1 PATTERN SELECT SWITCH ASSEMBLY
a.
1.01,1.583 1.479,1.125
true
2.333,1.594 1.917,1.135
true
*a | Component without harness connected
(No. 1 Pattern Select Switch Assembly) |
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection Condition Specified Condition 6 (MSW1) - 3 (MSW2) No. 1 pattern select switch assembly (SPORT) being pushed Below 1 Ω 6 (MSW1) - 3 (MSW2) No. 1 pattern select switch assembly (SPORT) not being pushed 10 kΩ or higher
If the result is not as specified, replace the No. 1 pattern select switch assembly.
b.
2.271,1.771 2.125,1.771
2.125,1.771 1.792,1.115
true
1.094,1.76 1.25,1.76
1.25,1.76 1.615,1.104
true
*a | Component without harness connected
(No. 1 Pattern Select Switch Assembly) |
Apply battery voltage to the No. 1 pattern select switch assembly and check that the No. 1 pattern select switch assembly illuminates.
- Standard:
Measurement Condition Specified Condition Battery positive (+) → 5 (MSW+)
Battery negative (-) → 4 (MSW-)Illuminates
If the result is not as specified, replace the No. 1 pattern select switch assembly.