LIGHTING (INT) LIGHTING SYSTEM OPERATION CHECK
INSPECT ILLUMINATED ENTRY SYSTEM OPERATION
- NOTICE:
-
Perform this inspection with the customize parameters at the initial settings.
- HINT:
-
The lights controlled by the illuminated entry system are as follows.
- ·
Engine Switch Illumination*1
·Transponder Key Coil*2
·No. 1 Room Light Assembly
*1: w/ Smart Entry and Start System
*2: w/o Smart Entry and Start System
The operation and conditions are described below.
| Operation | Condition |
|---|---|
| Fade in and illuminate constantly | Any door is opened when all doors are closed. |
| Illuminate for 15 seconds, and then fade out | When any of the following conditions is met, the interior lights illuminate for 15 seconds, and then fade out:
·
The key enters any actuation area around the doors when the ignition switch is off and all doors are closed.*1, *2 ·
Any door is unlocked when the ignition switch is off with all doors closed and locked. ·
The ignition switch is turned from ON or ACC to off when all doors are closed. ·
All doors are closed after any door is opened when the ignition switch is off. |
| Fade out immediately | When any of the following conditions is met, the interior lights fade out immediately:
·
The ignition switch is turned from off to ACC when all doors are closed. ·
All doors are locked when the ignition switch is off, all doors are closed and any door is unlocked. ·
All doors are locked again when all doors are already closed and locked. |
*1: When the lights are on, if the key leaves all of the actuation areas around the doors, after approximately 3 seconds, the lights fade out.
*2: w/ Smart Entry and Start System
INSPECT BATTERY SAVING FUNCTION
- NOTICE:
-
Perform this inspection with the customize parameters at the initial settings.
- HINT:
-
The lights controlled by the battery saving function are as follows.
- ·
Engine Switch Illumination*2
·Transponder Key Coil*3
·Map Light Assembly
·No. 1 Room Light Assembly
·No. 2 Room Light Assembly*2
·No. 1 Luggage Compartment Light Assembly
·Vanity Light Assembly LH and RH*1
*1: w/ Vanity Light
*2: w/ Smart Entry and Start System
*3: w/o Smart Entry and Start System
The operation and conditions are described below.
| Operation | Condition |
|---|---|
| Battery Saving | When 20 minutes elapse after the ignition switch is turned from ACC or ON to off and the lights that operate remain on, the lights are turned off.
|
*: w/ Smart Entry and Start System