LIGHTING (EXT) LIGHTING SYSTEM DATA LIST / ACTIVE TEST
DATA LIST
- NOTICE:
-
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
- HINT:
-
Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus:
for Main Body: Body Electrical / Main Body / Data List.
for Combination Meter: Body Electrical / Combination Meter / Data List.
Read the Data List according to the display on the GTS.
- Body Electrical > Main Body > Data List
-
Tester Display Measurement Item Range Normal Condition Diagnostic Note Parking Brake SW Parking brake switch signal OFF or ON OFF: Parking brake switch off
ON: Parking brake switch on- Dimmer SW Dimmer switch high position signal OFF or ON OFF: Dimmer switch in low position
ON: Dimmer switch in high or high flash positionw/ Light Auto Turn-off System Passing Light SW Dimmer switch high flash position (pass) signal OFF or ON OFF: Dimmer switch not in high flash position
ON: Dimmer switch in high flash positionw/ Light Auto Turn-off System Front Fog Light SW Fog light switch front position signal OFF or ON OFF: Fog light switch off
ON: Fog light switch in front positionw/ Light Auto Turn-off System Head Light SW (Head) Light control switch head position signal OFF or ON OFF: Light control switch not in head position
ON: Light control switch in head positionw/ Light Auto Turn-off System Head Light SW (Tail) Light control switch tail position signal OFF or ON OFF: Light control switch in neither tail nor head position
ON: Light control switch in tail or head positionw/ Light Auto Turn-off System Daylight Function Setting of the DRL function on/off OFF or ON Customize setting displayed w/ Daytime Running Light The Number of DTC Number of trouble codes 0 to 255 Number of stored DTCs displayed -
- Body Electrical > Combination Meter > Data List
-
Tester Display Measurement Item Range Normal Condition Diagnostic Note Turn Signal Switch (Right) Turn signal switch (right) signal OFF or ON OFF: Turn signal switch (right) off
ON: Turn signal switch (right) on- Turn Signal Switch (Left) Turn signal switch (left) signal OFF or ON OFF: Turn signal switch (left) off
ON: Turn signal switch (left) on- Hazard Flasher Switch Hazard warning signal switch signal OFF or ON OFF: Hazard warning signal switch off
ON: Hazard warning signal switch on-
ACTIVE TEST
- HINT:
-
Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / Main Body / Active Test.
Perform the Active Test according to the display on the GTS.
- Body Electrical > Main Body > Active Test
-
Tester Display Measurement Item Control Range Diagnostic Note Daytime Running Light Daytime running lights OFF or ON w/ Daytime Running Light Taillight Relay Taillight relay OFF or ON w/ Light Auto Turn-off System Headlight Relay H-LP relay OFF or ON w/ Light Auto Turn-off System Head Light Hi DIM relay OFF or ON w/ Light Auto Turn-off System Front Fog Light Relay Front fog light relay OFF or ON ·Light control switch in tail position
·w/ Light Auto Turn-off System