NETWORKING  LIN COMMUNICATION SYSTEM  DATA LIST / ACTIVE TEST  


DATA LIST


HINT:

Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.


NOTICE:

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Read the Data List according to the display on the GTS.

Body Electrical > Main Body > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Communication D-Door Motor Connection status between power window regulator motor assembly (for driver door) and main body ECU (multiplex network body ECU)*1 OK or STOP OK: Connected
STOP: Not Connected 		DTC is output if an error occurs in LIN communication.
Communication Slide Roof Connection status between sliding roof ECU (sliding roof drive gear sub-assembly) and main body ECU (multiplex network body ECU)*2 OK or STOP OK: Connected
STOP: Not Connected 		DTC is output if an error occurs in LIN communication.
The Number of DTC Number of DTCs 0 to 255 Number of stored DTCs -

*1: w/ Power Window System

*2: w/ Sliding Roof System


Body Electrical > Entry&Start > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
# Codes Number of DTCs* 0 to 255 Number of stored DTCs -

*: w/ Smart Key System