SPECIFICATIONS  2ZR-FE ENGINE CONTROL  SERVICE DATA  


SPARK PLUG
Standard Insulation Resistance Spark plug (terminal part) - Body ground 10 MΩ or higher
Spark Plug Type DENSO made SC20HR11
SC16HR11
Maximum Electrode Gap for Used Spark Plug 1.3 mm (0.0512 in.)
Standard Electrode Gap for New Spark Plug 1.0 to 1.1 mm (0.0394 to 0.0433 in.)

CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY
Standard Resistance 20°C (68°F) 6.9 to 7.9 Ω

THROTTLE BODY ASSEMBLY
Standard Throttle Valve Opening Percentage Shift lever in N 60% or higher
Standard Resistance 1 (M-) - 2 (M+) 20°C (68°F) 0.3 to 100 Ω

ACCELERATOR PEDAL SENSOR ASSEMBLY
Standard Voltage (Accele Sensor Out No.1) Accelerator pedal fully released 0.5 to 1.1 V
Accelerator pedal fully depressed 2.6 to 4.5 V
Standard Voltage (Accele Sensor Out No.2) Accelerator pedal fully released 1.2 to 2.0 V
Accelerator pedal fully depressed 3.4 to 4.75 V

MASS AIR FLOW METER SUB-ASSEMBLY
MAF
·

Engine not running

·

30 seconds after ignition switch turned to ON


0.29 gm/sec or less
Standard Resistance 1 (THA) - 2 (E2) -20°C (-4°F) 13.6 to 18.4 kΩ
20°C (68°F) 2.21 to 2.69 kΩ
60°C (140°F) 0.49 to 0.67 kΩ

CRANKSHAFT POSITION SENSOR
Standard Resistance Cold 1630 to 2740 Ω
Hot 2065 to 3225 Ω

ENGINE COOLANT TEMPERATURE SENSOR
Standard Resistance 20°C (68°F) 2.32 to 2.59 kΩ
80°C (176°F) 0.310 to 0.326 kΩ

KNOCK CONTROL SENSOR
Standard Resistance 25°C (77°F) 120 to 280 kΩ

AIR FUEL RATIO SENSOR
Standard Resistance 1 (HA1A) - 2 (+B) 20°C (68°F) 1.6 to 3.2 Ω
1 (HA1A) - 4 (A1A-) Always 10 kΩ or higher

HEATED OXYGEN SENSOR
Standard Resistance 1 (HT1B) - 2 (+B) 20°C (68°F) 11 to 16 Ω
1 (HT1B) - 4 (E2) Always 10 kΩ or higher

IG2 RELAY (IG2)
Standard Resistance 3 - 5 Battery voltage not applied between terminals 1 and 2 10 kΩ or higher
Battery voltage applied between terminals 1 and 2 Below 1 Ω

EFI-MAIN RELAY (EFI-MAIN)
Standard Resistance 3 - 5 Battery voltage not applied between terminals 1 and 2 10 kΩ or higher
Battery voltage applied between terminals 1 and 2 Below 1 Ω

C/OPN NO. 1 RELAY (C/OPN NO. 1)
Standard Resistance 3 - 5 Battery voltage not applied between terminals 1 and 2 10 kΩ or higher
Battery voltage applied between terminals 1 and 2 Below 1 Ω