U340E AUTOMATIC TRANSMISSION / TRANSAXLE  AUTOMATIC TRANSAXLE SYSTEM  INITIALIZATION  


RESET MEMORY


NOTICE:
·

Perform Reset Memory (AT initialization) when replacing the automatic transaxle assembly, engine assembly or ECM.

·

Reset Memory can be performed only with the GTS.



HINT:

The ECM memorizes the condition that the ECT controls the automatic transaxle assembly and engine assembly according to those characteristics. Therefore, when the automatic transaxle assembly, engine assembly, or ECM has been replaced, it is necessary to reset the memory so that the ECM can memorize the new information.

Reset Memory procedure is as follows.


a.

Turn the ignition switch off.


b.

Connect the GTS to the DLC3.


c.

Turn the ignition switch to ON.


d.

Turn the GTS on.


e.

Enter the following menus: Powertrain / Engine and ECT / Utility / Reset Memory.

Powertrain > Engine and ECT > Utility
Tester Display
Reset Memory
50005 234 1176
NOTICE:

After performing Reset Memory, be sure to perform the Road Test described earlier.

Click hereDrivetrain>U340E AUTOMATIC TRANSMISSION / TRANSAXLE>AUTOMATIC TRANSAXLE SYSTEM>ROAD TEST


HINT:

The ECM is learned by performing the Road Test.