METER / GAUGE / DISPLAY  METER / GAUGE SYSTEM  DATA LIST / ACTIVE TEST  


DATA LIST


NOTICE:

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


HINT:

Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.


a.

Warm up the engine.


b.

Turn the ignition switch off.


c.

Connect the GTS to the DLC3.


d.

Turn the ignition switch to ON.


e.

Turn the GTS on.


f.

Enter the following menus:

i.

for Combination Meter: Body Electrical / Combination Meter / Data List.


ii.

for ABS/VSC/TRC: Chassis / ABS/VSC/TRC / Data List.


iii.

for Engine and ECT: Powertrain / Engine and ECT / Data List.



g.

Read the Data List according to the display on the GTS.

i.

Combination Meter

Body Electrical > Combination Meter > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Tail Relay SW Tail relay OFF or ON OFF: Tail relay off
ON: Tail relay on 		-
ODO/TRIP Change SW ODO/TRIP switch ODO/TRIP switch OFF: Switch not pushed
ON: Switch pushed 		-
Vehicle Speed Meter Vehicle speed Min.: 0 km/h (0 mph), Max.: 255 km/h (158 mph) Almost the same as actual vehicle speed -
Engine Rpm Engine speed Min.: 0 rpm, Max.: 12750 rpm Almost the same as actual engine speed -
Coolant Temperature Engine coolant temperature Min.: 0°C (32°F), Max.: 127.5°C (261.5°F) 75 to 100°C (167 to 212°F) (After warming up engine) -
Multi Display Select Switch DISP switch OFF or ON OFF: DISP switch not pressed
ON: DISP switch pressed 		*1
+B Voltage Value Battery voltage Min.: 0 V, Max.: 25.5 V 11 to 14 V -
Fuel Input Fuel input Min.: 0 L, Max.: 127.5 L Fuel receiver gauge indicates F: 49.5 L
Fuel receiver gauge indicates 3/4: 40.8 L
Fuel receiver gauge indicates 1/2: 27.5 L
Fuel receiver gauge indicates 1/4: 14.2 L
Fuel receiver gauge indicates E: 5.5 L 		Unit: Liter
Ambient Temperature Outside temperature Min.: -40°C (-40°F), Max.: 87.5°C (189.5°F) Almost the same as actual outside temperature The temperature displayed on the multi-information display is -40 to 50°C (-40 to 122°F)
Oil Pressure Switch Oil pressure switch OFF or ON OFF: Engine started
ON: Engine not started 		-
Turn Signal Switch (Right) RH turn signal switch OFF or ON OFF: RH turn signal switch off
ON: RH turn signal switch on 		-
Turn Signal Switch (Left) LH turn signal switch OFF or ON OFF: LH turn signal switch off
ON: LH turn signal switch on 		-
Hazard Flasher Switch Hazard warning switch OFF or ON OFF: Hazard warning switch off
ON: Hazard warning switch on 		-
Key Remind Sound Cycle of the key reminder warning buzzer Normal, Slow, Fast Displays customize setting of Key Remind Sound -
Driver Side Seatbelt Warning Buzzer Setting of the driver seat belt warning buzzer OFF or ON OFF: Seat belt warning buzzer does not sound at vehicle speed of 20 km/h (12 mph) or more when driver seat belt unfastened
ON: Seat belt warning buzzer sounds at vehicle speed of 20 km/h (12 mph) or more when driver seat belt unfastened 		Displays customize setting of Driver Side Seatbelt Warning Buzzer
Units By Region Unit of the cruise information display Km/l JP, Ml/g US, Km/l, Ml/g UK, Km/g Displays customize setting of Units By Region*2 -
ECO Drive Indicator Zone Setting of the eco driving indicator zone OFF or ON OFF: Eco driving indicator zone not displayed
ON: Eco driving indicator zone displayed 		Displays customize setting of ECO Drive Indicator Zone*3
ODO Display Time After IG OFF Setting Setting of the ODO display time after the ignition switch is turned off 30s, 60s, 600s, OFF Displays customize setting of ODO Display Time After IG OFF Setting -
Number of Trouble Code The number of the DTC currently stored Min.: 0, Max.: 255 0 -

*1: for Multi-information Display (Dot LCD Type)

*2: for Multi-information Display (Segment LCD Type)

*3: for CVT



ii.

ABS/VSC/TRC

Chassis > ABS/VSC/TRC > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Vehicle Speed Maximum wheel speed sensor reading Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph) Vehicle stopped: 0 km/h (0 mph) When driving at constant speed: No large fluctuations

iii.

Engine and ECT

Powertrain > Engine and ECT > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Engine Speed Engine speed Min.: 0 rpm, Max.: 16383 rpm for 1ZR-FE:
600 to 700 rpm: Idling
for 2ZR-FE:
680 to 780 rpm: Idling (for CVT)
600 to 700 rpm: Idling (for Manual Transaxle)
for 2NZ-FE:
650 to 750 rpm: Idling 		When the crankshaft position sensor is malfunctioning, "Engine Speed" is approximately 0 rpm or varies greatly from the actual engine speed.
for 2NZ-FE:
Stored as Freeze Frame Data: Yes
Coolant Temp Engine coolant temperature Min.: -40°C (-40°F), Max.: 140°C (284°F) 75 to 100°C (167 to 212°F): After warming up engine This is the engine coolant temperature.
HINT:
·

After warming up the engine, the engine coolant temperature is 75 to 100°C (167 to 212°F).

·

After a long soak, the engine coolant temperature, intake air temperature and ambient air temperature are approximately equal.

·

If the value is -40°C (-40°F), or 140°C (284°F), the sensor circuit is open or shorted.

·

Check if the engine overheats when the value indicates 140°C (284°F).






ACTIVE TEST


HINT:

Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.


a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Combination Meter / Active Test.


e.

Perform the Active Test according to the display on the GTS.

Body Electrical > Combination Meter > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Speed Meter Operation Speedometer OFF, 0, 40, 80, 120, 160, 200, 240 There is a deviation in the values displayed on the speedometer (Control range → Speedometer)
Reference km/h:
·

40 → 41.7 to 46.2

·

80 → 83.4 to 88.4

·

120 → 125.1 to 130.6

·

160 → 166.2 to 173.2

·

200 → 207.7 to 215.7


TachoMeter Operation Tachometer OFF, 0, 1000, 2000, 3000, 4000, 5000, 6000, 7000 -
Fuel Meter Operation Fuel receiver gauge OFF, Sender E, Empty, Warning, 1/4, 1/2, 3/4, Full, Sender F -
A/T Indicator Operation 1 Shift indicator OFF, L, 2, 3(M), 4(M), D, N, R, P *2, *5
A/T Indicator Operation 2 Shift indicator OFF, 5, 6, 7, M *2
A/T Indicator Operation 3 Shift indicator OFF, D *2
Indicat. Lamp Airbag SRS warning light OFF or ON -
Indicat. Lamp Doors All Open Door open warning light OFF or ON *1
Driver Side Seat Belt Driver seat belt warning light OFF or ON -
Indicat. Lamp ABS ABS warning light OFF or ON *4
Indicat. Lamp Charge Charge warning light OFF or ON *1
Indicat. Lamp Coolant Hot Engine coolant temperature hot warning light OFF or ON *1
Indicat. Lamp Tail Tail indicator light OFF or ON -
Indicat. Lamp Fuel Fuel level warning light OFF or ON -
Indicat. Oil Pressure Engine oil pressure warning light OFF or ON *1
Indicat. ECONO Eco driving indicator light OFF or ON *1, *5
Indicat. Lamp Brake Brake warning light OFF or ON -
Indicat. EPS EPS warning light OFF or ON -
Master Warning Master warning light OFF or ON *3
Turn Signal (Left) Indicator LH turn indicator light OFF or ON -
Turn Signal (Right) Indicator RH turn indicator light OFF or ON -
Water Temperature Meter Operation Engine coolant temperature receiver gauge OFF, LOW, NORMAL, HIGH -
Meter Display 1 Multi-information display
·

Multi-information display (Dot LCD type):

OFF, All

·

Multi-information display (Segment LCD type):

OFF, 6, 5, 4, 3, 2, 1, 0, All


-
Meter Display 2 Multi-information display (Segment LCD type) OFF, 9, 8, 7 *1

*1: for Multi-information Display (Segment LCD Type)

*2: for CVT

*3: for Multi-information Display (Dot LCD Type)

*4: w/ ABS

*5: for Automatic Transaxle