WINDOW / GLASS POWER WINDOW CONTROL SYSTEM Front Passenger Side Power Window does not Operate with Front Passenger Side Power Window Switch
DESCRIPTION
When the ignition switch is ON, the power window regulator motor assembly (for front passenger door) is operated by the power window regulator switch assembly.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
- NOTICE:
- ·
Inspect the fuses for circuits related to this system before performing the following procedure.
·Check that the window lock switch is off before performing the following procedure.
PROCEDURE
Disconnect the H11 power window regulator switch assembly connector.
Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection Condition Specified Condition H11-3 (B) - Body ground Ignition switch ON 11 to 14 V
- Result:
Proceed to OK NG
OK
NG
Remove the power window regulator switch assembly.
Click hereVehicle Exterior>WINDOW / GLASS>FRONT PASSENGER SIDE POWER WINDOW SWITCH>REMOVAL
Inspect the power window regulator switch assembly.
Click hereVehicle Exterior>WINDOW / GLASS>FRONT PASSENGER SIDE POWER WINDOW SWITCH>INSPECTION
- Result:
Proceed to OK NG
OK
NG
Disconnect the H12 power window regulator motor assembly (for front passenger door) connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection Condition Specified Condition H11-4 (U) - H12-2 (U) Always Below 1 Ω H11-4 (U) or H12-2 (U) - Body ground Always 10 kΩ or higher H11-1 (D) - H12-1 (D) Always Below 1 Ω H11-1 (D) or H12-1 (D) - Body ground Always 10 kΩ or higher
- Result:
Proceed to OK NG
OK
NG
Remove the power window regulator master switch assembly.
Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW MASTER SWITCH>REMOVAL
Inspect the power window regulator master switch assembly.
Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW MASTER SWITCH>INSPECTION
- Result:
Proceed to OK NG
OK
NG
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection Condition Specified Condition G11-12 (U) - H11-5 (SU) Always Below 1 Ω G11-12 (U) or H11-5 (SU) - Body ground Always 10 kΩ or higher G11-13 (D) - H11-2 (SD) Always Below 1 Ω G11-13 (D) or H11-2 (SD) - Body ground Always 10 kΩ or higher
- Result:
Proceed to OK NG
OK
NG